TLP651 2002-09-25 1 toshiba photocoupler gaa ? as ired & photo ? ic TLP651 digital logic ground isolation line receiver microprocessor system interfaces switching power supply feedback control analog signal isolation the toshiba TLP651 consists of a gaa ? as high ? output light emitting diode and a high speed detector of one chip photo diode ? transistor. this unit is 8 ? lead dip. TLP651 has internal base connection. this base pin should be used for analog application or enable operation. if base pin is open, output signal will be noisy by enviromental condition. for this case, tlp650 is suitable. isolation voltage: 5000v rms (min.) switching speed: t phl = 0.3s (typ.) t plh = 0.5s (typ.) (r l = 1.9k ? ) ttl compatible ul recognized: ul1577, file no. e67349 bsi approved: bs en60065: 1994 certiticate no. 7613 bs en60950: 1992 certiticate no. 7614 pin configuration (top view) schematic toshiba 11 ? 10c4 weight: 0.54g unit in mm
TLP651 2002-09-25 2 maximum ratings (ta = 25c) characteristic symbol rating unit forward current (note 1) i f 25 ma pulse forward current (note 2) i fp 50 ma peak transient forward current (note 3) i fpt 1 a reverse voltage v r 5 v led diode power dissipation (note 4) p d 45 mw output current i o 8 ma peak output current i op 16 ma output voltage v o 0.5~15 v supply voltage v cc 0.5~15 v base current i b 5 ma emitter base reverse voltage v eb 5 v detector output power dissipation (note 5) p o 100 mw operating temperature range t opr 55~100 c storage temperature range t stg 55~125 c lead solder temperature (10s) (note 6) t sol 260 c isolation voltage (ac, 1min., r.h. 60%) (note 7) bv s 5000 v rms (note 1) derate 0.8ma above 70c. (note 2) 50% duty cycle,1ms pulse width. derate 1.6ma / c above 70c. (note 3) pulse width 1s, 300pps. (note 4) derate 0.9mw / c above 70c. (note 5) derate 2mw / c above 70c. (note 6) soldering portion of lead: up to 2mm from the body of the device. (note 7) device considered a two terminal device: pins 1, 2, 3 and 4 shorted together and pins 5, 6, 7 and 8 shorted together.
TLP651 2002-09-25 3 electrical characteristics (ta = 25c) characteristic symbol test condition min. typ. max. unit forward voltage v f i f = 16ma D 1.65 1.85 v forward voltage temperature coefficient ? v f / ? ta i f = 16ma D 2 D mv / c reverse current i r v r = 5v D D 10 a led capacitance between terminal c t v f = 0, f = 1mhz D 45 D pf i oh (1) i f = 0ma, v cc = v o = 5.5v D 3 500 na i oh (2) i f = 0ma, v cc = v o = 15v D D 5 a high level output current i oh i f = 0ma, v cc = v o = 15v ta = 70c D D 250 a detector high level supply voltage i cch i f = 0ma, v cc = 15v D 0.01 1 a ta = 25c 10 30 D rank: o 19 30 D ta = 0~70c 5 D D current transfer ratio i o / i f i f = 16ma v cc = 4.5v v o = 0.4v rank: o 15 D D % low level output voltage v ol i f = 16ma, v cc = 4.5v, i o = 1.1ma (rank 0: i o = 2.4ma) D D 0.4 v isolation resistance r s r.h. 60%, v s = 500v dc (note 7) 510 10 10 14 D ? coupled capacitance between input to output c s v s = 0, f = 1mhz (note 7) D 0.8 D pf switching characteristics (ta = 25c, v cc = 5v) characteristic symbol test cir cuit test condition min. typ. max. unit i f = 0 16ma, v cc = 5v, D 0.2 0.8 propagation delay time (h l) t phl r l =4.1k ? rank o: r l =1.9k ? D 0.3 0.8 s i f = 16 0ma, v cc = 5v, D 1.0 2.0 propagation delay time (l h) t plh 1 r l =4.1k ? rank o: r l =1.9k ? D 0.5 1.2 s common mode transient immunity at logic high output (note 8) c mh i f = 0ma, v cm = 200v p p r l = 4.1k ? (rank o: r l = 1.9k ? ) D 400 D v / s common mode transient immunity at logic low output (note 8) c ml 2 i f =16ma, v cm = 200v p p r l = 4.1k ? (rank o: r l = 1.9k ? ) D 1000 D v / s
TLP651 2002-09-25 4 (note 8) cm l is the maximum rate of fall of the common mode voltage that can be sustained with the output voltage in the logic low state (v o < 0.8v). cm h is the maximum rate of rise of the common mode voltage that can be sustained with the output voltage in the logic high state (v o > 2.0v). (note 9) maximum electrostatic discharge voltage for any pins: 100v (c = 200pf, r = 0). test circuit 1: switching time test circuit test circuit 2: common mode noise immunity test circuit
TLP651 2002-09-25 5
TLP651 2002-09-25 6
TLP651 2002-09-25 7 toshiba is continually working to improve the quality and reliability of its products. nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. it is the responsibility of the buyer, when utilizing toshiba products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such toshiba products could cause loss of human life, bodily injury or damage to property. in developing your designs, please ensure that toshiba products are used within specified operating ranges as set forth in the most recent toshiba products specifications. also, please keep in mind the precautions and conditions set forth in the ?handling guide for semiconductor devices,? or ?toshiba semiconductor reliability handbook? etc.. the toshiba products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). these toshiba products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (?unintended usage?). unintended usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. unintended usage of toshiba products listed in this document shall be made at the customer?s own risk. gallium arsenide (gaas) is a substance used in the products described in this document. gaas dust and fumes are toxic. do not break, cut or pulverize the product, or use chemicals to dissolve them. when disposing of the products, follow the appropriate regulations. do not dispose of the products with other industrial waste or with domestic garbage. the products described in this document are subject to the foreign exchange and foreign trade laws. the information contained herein is presented only as a guide for the applications of our products. no responsibility is assumed by toshiba corporation for any infringements of intellectual property or other rights of the third parties which may result from its use. no license is granted by implication or otherwise under any intellectual property or other rights of toshiba corporation or others. the information contained herein is subject to change without notice. 000707ebc restrictions on product use
|
